Pipe boot and vent leaks
Cracked rubber collars around pipes
EPDM is a rubber membrane used on flat roofs, bonded rather than welded, with seams made using tape or adhesive. It fails at those seams, at upstands where the material turns up a wall, and through shrinkage over time pulling the membrane away from its terminations. It is durable in the field and repairable almost indefinitely, so a leaking EPDM roof is rarely a replacement job.
Pendergrass sits in the metro Atlanta hail and wind corridor. Spring storm season here does two kinds of damage, and only one of them is obvious. Straight-line wind lifts shingle tabs, breaks the seal strip underneath, and drops them back down looking untouched — the roof then leaks in the next storm from a spot that shows nothing from the ground. Hail does the other kind, bruising the mat under the granules so the shingle fails months later. Housing stock across Jackson County skews newer and denser than most of the state, which means a lot of architectural asphalt in the 10-to-20-year band where the seal strip is past its best but the roof is nowhere near replacement.
Pendergrass has a population of about 1,692, and the housing stock here sets the pattern for what fails first on a roof.
Over many years, slightly — enough to put tension on upstands and terminations, which is where older rubber roofs most often fail. It is repairable by releasing and redressing the affected edge rather than recovering the roof.
No. They are different chemistries and the adhesives and tapes are not interchangeable. Using TPO products on EPDM produces a repair that looks fine and fails within a season.
Cracked rubber collars around pipes
Where two roof slopes meet
The metal at the roof edge
Missing, cracked or lifted shingles
Single-ply flat roof membrane
Lifted tabs and broken seals
You will get a straight answer on whether Pendergrass needs someone out today or whether it can wait — before anyone quotes you for anything.
Call (229) 235-1425